Waves Plug-in for Vocals and Monophonic Bedienungsanleitung

Waves Tune Tuning Correction Plug-in for Vocals and Monophonic Sound Sources. Software Users Guide

Minutes/Sec – Here, the timeline is displayed display in Minutes/Seconds. The timeline will be limited to ten minutes, after which pitch detection wil

Note Tune: When the Edit Scale button is on, each of the 12 notes will show its temperament, in cents. Tune can be adjusted to perfect the notes’ in

The corrected pitch graph may be further edited using a few simple tools that change the appearance of the mouse pointer in context with its current f

Waveform: Waveform defines the shape of the synthetic vibrato which will be applied to a selection. Choices are: sine, triangle, square, saw up, saw

Clear Graph – Clears the Detection and Correction curves from the selected area, clearing all analysis for that region. During subsequent playback, T

WAVESYSTEM The WaveSystem Toolbar provides standard functions such as preset Save/Load handling, Help button etc. This is common to all Waves Plug-i

tunes such as 443. Music transferred from analogue tape can exhibit pitch variances due to playback speed inconsistencies. However you determine the

Part 3: Post Scan – General corrections After performing the scan, Tune constructs the detected pitch curve and correction curve. From this point o

This can cause an artifact which has become a creative effect occasionally (incorrectly) referred to as the “Cher Effect.” Ratio: Here, you determi

In the opposite case, Tune might remain at the same note, although the singer was supposed to go to the next one. Here the Slice tool allows segmenti

Introduction and Overview Waves Tune is a software audio processor which allows for correction and manipulation of pitch in vocals and monophonic ins

stepping forward until you make a change and the Undo History is broken. In this case the Redo button becomes grayed out and isn’t available. Remembe

Quick Start INSERTING THE PLUG-IN To get started, insert Tune onto your vocal track (or monophonic instrument track.) It is important that Tune pr

cleared, it will automatically begin scanning. The sound output will remain uncorrected during the scan, but an orange highlight will appear to indic

Tune Interface Reference The Tune Interface is divided into the following sections – • Global Correction section • Segmentation section • Correct

SEGMENTATION SECTION: The Segmentation section allows you to select conditions by which Tune will segment the correction curve into notes. These c

natural vibrato manipulation after you turned the segmentation on and natural vibrato was detected, in other words only the segmentation button will p

The Note tool allows you to select a note or multiple notes in the Edit Window and perform various actions on anything within the selection. Select si

PITCH EDIT GRAPH: The Pitch Edit Graph fills the largest part of the Tune interface. There are four main parts to the Pitch Edit Graph: • Waveform